- Positioning was calculated using `boundingRect` while `transformOriginPoint` was set according to `tightBoundingRect`, causing mismatch when `QGIDatumLabel` contains more than text (eg. shapes around text). Now `transformOriginPoint` and positioning calculated according to `tightBoundingRect`, and setting `transformOriginPoint` of `QGIDatumLabel` are handled by itself. This fixes an issue where the gap between dimension lines and text varied depending on dimension's angle.
- `m_lineWidth` was set in multiple locations, causing confusion and bug introduction
- If `X` or `Y` property changed, the remaining changed properties were not handled due to using `if else` rather than `if` for property change checking. This became an issue due the above mentioned simplification of `m_lineWidth` setting: if `X` or `Y` had changed (upon document restore).
- Center position was uneededly saved in variables `posX` and `posY` when it could be calculated on demand using `tightBoundingRect`. Removing this uneeded state simplfies code and lowers the risk of bug introduction due to lack of updating state.
The 'CTRL to snap' option is not the default, it should therefore not be included in the tooltips.
Additionally:
* Some obsolete info was removed.
* Some minor improvements,
This patch introduces a few things:
- changes Activate button to be first in the list
- puts it in bold text, also adding (Default) to point it is default
action
- removes all of the hiding logic upon double click and leaving Activate
by default to be called after double-clicking a BuildingPart
Currently, for both Help and BIM Views panels we can get a traceback
about incorrect casting if we move the panel.
This is because the QFlag of DockWidgetArea that is being passed, as it is not
able to be parsed down to an int. Most probably some historical change
either in Qt or FC.
This error also caused to not write current BIM Views/Help panel setup
to config, resulting in the position being resetted every run.
As the title says - those two tools missed IFC attributes, since they
used different path of initialization than other components, so this
patch makes sure we initialize those properties properly.
Fixes#21501.
For some fonts `Part.makeWireString()` returns characters that are much smaller than the given height. This would lead to a false positive for the 'sticky font' check (which checks the area of the "L" character).
Single lines and polylines from 'l' instructions are imported as
Draft::Wire objects and grouped with an App:Part object so that
the lines contained in the obj file are included in the
corresponding object definition.
Single lines defined in the obj file within a block are converted
into a non-closed polyline if the second point of a line matches
the first point of the following line.
Fixes#21326
