Due to a flaw in the QUiLoader, UiLoader were loading all designer plugins
it can find in QApplication::libraryPaths(). This in general a bad
practice and leads to bugs due to some plugins may perform some unexpected
actions upon load which may interfere with FreeCAD's functionality.
To avoid such problems reset the libraryPaths before creation of a
UiLoader object.
Also move setLanguageChangeEnabled(true) into constructor due to it's
called every time it's being instanced anyway.
See: https://github.com/FreeCAD/FreeCAD/issues/8708
================================================
This should fix this (I cannot reproduce it):
https://forum.freecad.org/viewtopic.php?p=667579#p667579
Lately I added the geometry pointer to the item. This has indeed
the potential for an already deleted pointer being accessed.
This PR removes the geometry pointer from the item and relies on the
ViewProvider to indirectly access an updated pointer.
===============================================================
For translated notifications now the caption is included in the
message, as the translation is already done, and this improves
the semantics of existing messages.
====================================================================================
As reported:
https://forum.freecad.org/viewtopic.php?p=667426#p667426
Support for moving external geometry to another layer will come in the future.
This commit adds the ability to shift the involute profile inside or
outside. Profile shift is implemented as coefficient, i.e. normalized by
the module, so that it the whole profile scales with the module without
chaning shape.
To verify the profile, the tests implement an "over pins measurement"
using formulae found in literature.
Backward compatibility with FreeCAD-v0.20 is garanteed by already
existing tests, not touched by this commit.
This addresses issue #5618.
- the heat capacity of water was wrong
- also specify just thermal expansion, this make that water is recognized as material and then all water parameters will be available
(that the analysis fail despite CalculiX reports everything went well s is another issue, I will investigate later)
- the density must be output using the correct units. Due to this bug also the viscosity was written with wrong units-
- if there is a dynamic viscosity given for a material, use it directly
