=================================================
This method creates the pole circles on every click. This allows to properly detect the closing of the curve
=====================================================================
Extension of Constraint Python code to consider the case with 4 ints, where the last int is InternalAligmentIndex for InternalAligment constraint
==================================================
Now the BSpline ends with right-click, but creates the BSpline if at least two poles have been entered.
If continous creation mode is enabled, then it only exits when right-clicking without having entered any pole.
===================================
In the unusual event that endpoint knot multiplicity is edited, avoid trying to force the bspline end-point
to match the corresponding control point (aka pole), as this leads to unsolvable sketches.
=====================================================================================
Support for tangency/perpendicularity using angle via point for BSpline with appropriate
endpoint multiplicity so that the endpoints goes thru the first and last poles (control points).
Warning: Not applicable to periodic BSplines.
Warning: Not applicable to any non-periodic BSpline with inappropriate endpoint conditions.
==============================================
This commit is intended to allow to early merging to master of BSpline support. Parts of it will be reverted when a more advanced solver implementation is available.
The intention is to have an advances solver implementation in the future.
This commit cripples part of the potential functionality, but allows a very simplistic solver structure (no de Boor, no recursion).
In particular:
1. Knots are not solver parameters and the solver acts as if such a parameter did not exist.
2. For non-periodic case, the start point and the endpoint coincide with the first pole and the last pole respectively. This is only valid under certain first and last
knot multiplicity. If the user manually changes this multiplicities, the sketch will remain unsolved. For the periodic case, end and start points are not even solver
parameters as an end and start point is an ilusion and we really do not care where that happens. It is not reasonable to ask the user to constrain where this point should
be.
===================================
An additional index for internal geometry elements is introduced, to be stored only Internal Aligment constraint and backwards compatible.
=============================================================
Internal alignment of BSplines requires an extra index for unbounded same-type internal geometry (poles, probably also in the future knots).
Value shall not be used, as it interferes with the update mechanism for constraint values.
An alternative solution would be to add another int to all the constraints just for this case.
As internal geometry does not use Third, it seems reasonable to reuse it for this indexing purpose.
