- the heat capacity of water was wrong
- also specify just thermal expansion, this make that water is recognized as material and then all water parameters will be available
(that the analysis fail despite CalculiX reports everything went well s is another issue, I will investigate later)
- make the connection also working for frequency and buckling analysis by directly creating/updating the pipeline where the CalculiX results are loaded
- when looking at the Elmer input file 'case.sif' it is extremely helpful to thee also the name of the material
Since the name is only form info, this does not change the actual simulation
- output equation-specific values only if this equation is used
- use Elmer's default for BDF order as default for FC too and allow to change it
- don't hardcode to Steady State. Transient must be possible too, this way add parameters to run a transient analysis
- the usually mandatory setting DisplaceMesh was missing leading to imprecise results. Now the calculated faceload is almost the exact same as with CCX
- also add most of the other settings Elmer 9 provides
- also add tooltips
- we must not hardcode the number of coincidence vector places
The user must have a chance to change this setting for the iterative solvers according to the Z88 docs.
We use as default the number Z88 uses in its distributed example.
(I doubt that it is sensible to check if a hardcoded memory value is written. The test will fail if you use a non-default memory setting on your FreeCAD. The CI uses of course the default)
- since we use consistently SI units (as recommended my the Elmer forum), we need to scale the input mesh (we use ElmerGrid that has an option fur this purpose)
- Since the result will be in the scaled mesh, we need to scale it back
With this PR, one gets now correct result independent of
- the used unit scheme
- the simulation type (electrical or thermo-mechanical)
Fixes two errors introduced in/due to 7621382272ae712ebf4493d996d1a1a918e95df7.
First one is a typo. The writer used "translations" where the reference file for
the test used "translation". Went with "translation" since that was mentioned in
the comment just above.
Second one is some missed out new lines in the reference file
`.../constraint_transform_beam_hinged.inp`. These lines were added in
`.../frequency_beamsimple.inp` but not here.
