- one needs to specify a file when calculating the capacitance matrix
- add electric flux to point filter results
- add missing parameters
- also some sorting
- update tolerances also for existing analyses to fix the bug that users see e.g. "0.001" and not the actual used tolerance
- also a fix for new stress analyses
- also a formatting fix
- output equation-specific values only if this equation is used
- use Elmer's default for BDF order as default for FC too and allow to change it
- don't hardcode to Steady State. Transient must be possible too, this way add parameters to run a transient analysis
- the usually mandatory setting DisplaceMesh was missing leading to imprecise results. Now the calculated faceload is almost the exact same as with CCX
- also add most of the other settings Elmer 9 provides
- also add tooltips
- reverts commit d296732d - the scaling it correct
- there is a bug in Elmer that the heat source is not aware of the scaling
- write the scaling directly to the solver, not to the mesh itself. (make in principal no difference but we are closer to the solver)
- currently for Z88 nothing happens when clicking the Edit button in the solver task dialog. The reason is that opening *.txt files was never implemented
- also do this for Elmer
- for Z88 we need to open several file for a proper editing because the solver info is distributed over these files
- it turned out that despite not mentioned in the manual, ElmerGUI adds the Stabilize setting for all setups
-> bring "Stabilize" back for all equations
(for "Bubbles" it is correct that this is an equation-specific setting)
- enable the disabled options. They work and are according to the Elmer manual. The user is free to use them or not and since they are all False by default, existing analyses won't be affected.
- add two missing settings
- for new equations, enable at least one calculation, otherwise nothing will happen when an inexperienced user uses the default
- the mesh scaling was a hack to work around the fact that FC's mesh is in mm while all input units are in SI. It turned out that this made more problems than it solved because Elmer checks the length unit and makes internal recalculations. So the mesh must not be scaled when send to Elmer (despite the ElmerGrid docs doesn't state this).
forum thread: https://forum.freecadweb.org/viewtopic.php?p=614162#p614162
- for BiCGstabl the minimal degree is 2, but 3 is recommended
- when adding the equation, it should do something, therefore enable the calculation of the principal stresses (as it was, nothing was calculated except of the displacement)
- while for CCX we output the eigenfrequency, for Elmer the user had to perform the calculation of a sqrt of the complex result.
This is inconvenient and error-prone and also requires the knowledge where the result is output by Elmer and in what format. (cast me more than an hour to find this out)
Therefore perform the calculation for the user and output the result.
- when the binary was not found, the function called the non-existing binary
- also push error message to the status info so that user gets feedback also when report view console is not shown
- when the binary was not found, the function called the non-existing binary
- also push error message for Elmer and Z88 to the status info so that user gets feedback also when report view console is not shown
- uniform wording to 'binary'
- avoid unnecessary console output
- this needs proper testing, especially on a non-Windows system
- note that for some tasks multi-threading requires non-standard additional solvers like MUMPS. Ideally the user should be informed about this, depending on the equations he uses. But this should not block this PR, meaning to use multi-threading in general.
- for Elmer and Z88 on Windows several windows pop up (console windows). This is maybe annoying and the user is wondering what is going on, but the main problem is that when you close them, you break the solving process.
Therefore, on Windows only, hide the empty popup windows.
