=====================================================================
fixes#4241
Problem:
PartDesignGui::ViewProvider is responsible for closing the tasks for most of PD features when exiting edit mode
(i.e. unsetEdit()).
For primitives, PartDesignGui::ViewProviderPrimitive is responsible, and neither does it or relies on its parent
VP to do it when calling unsetEdit().
Solution:
Make PartDesignGui::ViewProviderPrimitive::unsetEdit() rely on parent PartDesignGui::ViewProvider to tidy up,
including closing the task dialog.
Reference:
This is the default stack call when closing a document while a PD task using PartDesignGui::Viewprovider is active:
Reduce cumulative error by holding onto the original point in a sequence
of linear optimizations. In testing, this fixes artifacts I have seen on
very finely sampled paths with very gradual curvature.
Further improvements are needed for this optimization, but at least this
change avoids a regression over the status quo.
===========================================
fixes#4324
A multiline error message produces poor visualisation when used in the UI, while
there is no need for it to be multiline.
Slightly clean up the code by separating linear segment optimization
from gcode generation. While the current optimization is not very
effective once there is any kind of meshing noise, having a single
method performing the optimization will make it easier to tweak
tolerances or strategies.
Extend the work from #3496 to allow the safe optimization of more
complex step transitions.
- Use the actual safePDC path for short step transitions and breaks,
currently up to 2 cutter diameters. This value is chosen to cover
basically all typical end step-overs, including those with heavy skew.
Extending this much further (up to the break even point for a retract &
rapid) will need some careful thinking for multi pass paths.
- Coordinate offset tolerances with per-operation tessellation
tolerances, to avoid tessellation artifacts messing up paths by
causing false retracts. Such retracts can cause entire steps near
vertical areas to be falsely skipped, which would cause a major
deviation from the target model. By considering per-job tolerances, we
allow users to safely save computational resources by computing roughing
operations with lower precision, or selectively increase precision for
finish passes.
- Refine the default tessellation tolerance to GeometryTolerance / 4.
This makes sure that the job GeometryTolerance is respected by
operation defaults.
The `Part::Vertex` object has both `Placement`, and `X`, `Y`, `Z`
properties. The net displacement is the sum of both of these two
properties.
Previously, the `PointArray` would only use the `Placement`
which would produce a seemingly erroneous result
because `X`, `Y`, and `Z` would be ignored.
Also perform several improvements such as PEP8 cleanup,
write complete docstring, type checking of the input arguments,
accepting a full placement to modify the position,
and deprecating the older call.
Update the Gui Command as well.
