It is important to not include the original in the pattern because the original might not be at the tip of the feature tree. Including the original
will interfere with changes that occur further down in the feature tree
This fixes the bug identified in
https://forum.freecadweb.org/viewtopic.php?f=3&t=64900
- Use fuzzy fuse/cut method with tolerance Precision::Confusion()
- Use parallel computation feature
- Allow that individual patterned item fail to intersect the baseobject.
Issue warning instead of error. This was done for performance reasons
but it can also be considered a feature.
- Simplify the code a bit
- Distinguish between overlapping mode and non-overlapping mode. In non-overlapping mode
the tool shapes are compounded instead of fused. For huge benefit in performance.
Repurpose DressUp.SupportTransform property to define the following
behavior,
* When disabled (default), only the dressing will be used for patterning.
* When enabled, the additive/subtractive shape of the dressed base
feature will be used for patterning. Any dressing that is not applied
to the based feature will be ignored.
* If the dressing is applied to non-additive/subtractive feature, then
only the dressing will be used for patterning.
New API FreatureAddSub::getAddSubShape() is added to account for the
fact that a dressing (e.g. a fillet) can be either additive or
subtractive, which means that a DressUP feature may contain both
additive and subtractive shapes.
FeatureTransformed is modified to perform both fusion and cut if
required.
resolves#2683
Adds Refine property to sketch-based and transformation features. The
property is initialized according to preferences, and can be altered in
property editor on per-feature basis.
-Rename Sketchbased to ProfileBased to show new behavior
-Adopt ProfileBased to make the relevant helper functions work with faces too
-Adopt features for unified use of helper functions
-Adopt commands to allow face selection
subj;
Make PasrtDesign::Transformed provide common for all features
classes interface getBaseObject() instead of specific getSupportObject ();
Refactor some TransformedParameters methods.
Fixed crash after rejecting a MultiTransform dialog
remove overlap check
adding getSolid to cut operation
add extrema method to part::checkinterference
move refineshape call out of loops
divideTools functions
- remove StdDirection,StdAxis and StdMirrorPlane properties
- support sketch H_Axis, V_Axis, N_axis as valid references in patterns
- polish reference selection gui (unified for standard axes and custom references)
